Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Clothesline Prop Head For 1/2 in EMT
A 170 mm crossbar head that slides onto a 1/2 in EMT conduit pole (17.9 mm OD, 18.3 mm bore, 36 mm deep), so you can make a clothesline prop. It has four round-bottom line notches at 44 mm spacing to keep up to four lines apart, and an M4 self-tapping lock screw that stops the head from spinning on the pole.
608 Bearing Clothesline Pulley Wheel
A 70 mm replacement pulley wheel for old clothesline brackets whose original wheel has seized or cracked. The bracket stays where it is. A 608 bearing (8 x 22 x 7 mm) press-fits into a 22.05 mm pocket and runs on an 8 mm (M8 or 5/16 in) axle bolt. The wheel is 15 mm thick at the hub, so it fits any fork with at least 16 mm between the cheeks; washers take up any extra width. The 90° V-groove, 5 mm deep, holds clothesline up to about 6 mm thick.