Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
PL-259 And BNC Double V-Jaw Coax Wrench
This is a flat 153 mm double-ended wrench with a 60° V-jaw at each end. The large jaw is 28 mm wide at the mouth and wedges round or hex coupling nuts from about 10 to 26 mm, which covers PL-259/SO-239 and N connectors. The small jaw is 16 mm wide and takes about 5–14 mm, for BNC, SMA and F connectors. Because the V grips by wedging, no exact nut size is needed. You can snug and loosen coax at an antenna or radio without crushing the knurl with pliers. It prints flat, 8 mm thick, so the turning load runs along the layers, and it has a 5.5 mm hole for hanging it on a peg.
Single-Gang Pre-Terminated Cable Pass-Through Plate
This single-gang wall plate (70 x 114 mm, the 2.75 x 4.5 in standard size) has a 28 x 20 mm port that a moulded RJ45 plug or F-connector can pass through. An 8 mm side slit lets you slip the plate over Cat6 or RG6 that is already pulled, so you don't have to cut off factory connectors. The screw holes are slotted 4.2 mm wide over 79.5–83.8 mm centres, which covers the standard 83.3 mm (3-9/32 in) spacing of US device boxes and low-voltage brackets with #6-32 screws.
Three-Lane Cat6 And Coax Raceway Clip
A low-profile clip that screws to a baseboard or stud and holds three network or camera cables side by side. The 8.4 mm lanes on an 11 mm pitch take cables from 5.5 to 8 mm OD, which covers Cat5e, Cat6 and RG6 coax. Each cable snaps in through a 5.2 mm throat with a V lead-in, so you can run a clean line of drops without a full raceway. The clip is 56 x 11.6 x 16 mm. It prints on its end, so there are no overhangs and the snap lips flex along the layers instead of across them. It mounts with two #6/#8 wood screws or M4 screws through 4.5 mm holes on 45 mm centres.
Wire Dipole Antenna Center Insulator
Centre insulator for a wire dipole or inverted-V: a 140 x 76 mm ribbed plate with a wrap-post cleat on each leg (3.8 mm entry/exit holes for #14 AWG THHN at ~3.4 mm OD, around a 7 mm post) so the antenna tension is carried by the plastic instead of the solder joint. The 42 mm coax tail has three zip-tie stations (3.0 x 5.5 mm slot pairs on 18 mm centres) that strain-relieve RG-58, RG-8X or RG-213, and the top tab carries an 8.4 mm rope eye plus two M4 clearance holes (4.5 mm) for bolting to a mast plate.