Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Magnet Wire Five-Lane Spool Rack
A bench rack for small magnet-wire spools, sorted by AWG. Spools up to about 85 mm OD with any bore of 8.5 mm or more ride on an 8 mm steel rod (at least 170 mm long) held in 8.3 mm slip-fit bores 45 mm above the bench. Each wire feeds through its own numbered front eyelet (1 to 5 index dots), and a pinch slit beside each eyelet holds the loose end so fine winding wire stops unspooling in the drawer. The rack is 166 x 100 x 55 mm.
Universal Toroid Winding Cradle
A bench cradle with a tapered double-V pocket. It holds a toroid or ferrite core upright while you wind it. The pocket narrows from 18 mm at the top to 3 mm at the floor, so it wedges cores about 3–18 mm thick, and the 36° end ramps centre any OD from a T-50 (12.7 mm) up to an FT-240 (61 mm). The winding hole stays clear above the 28 mm tall jaws. It also has a 1.5 mm slit to hold the wire tail, and the 110 x 50 mm base takes two M4 or #8 screws through 4.5 mm holes on a 94 mm pitch.