Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flex-Fin Console Cubby Three-Cell Tray
A 100 x 64 x 28 mm three-cell parts tray for odd-shaped car console and glovebox cubbies. Angled 1.7 mm flex fins on both long sides make it 72 mm wide, and they fold in to grip any cubby 66–72 mm wide and at least 100 mm long, so it doesn't rattle. It has one 57 x 60 mm main cell, two 37 x 29 mm small cells and a finger notch for lifting it out.
Snap-Off PC And Console Foot Set
This is a set of four tapered 34 mm feet, 12 mm tall, joined by thin snap-off bridges. They replace the lost feet on PC towers, consoles, amplifiers and project boxes, and lift the case back up off the desk so the vents can breathe. Each foot fastens with an M3 screw through a 3.4 mm clearance hole. The screw head sits in a 6.5 mm counterbore under a 14 mm × 2 mm recess, where you can stick a rubber bumper. The top face is flat, so you can also use VHB tape if there's no screw boss.