Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flip-Up Toggle Switch Safety Guard
A surface-mount safety cover that prints in place with its hinge. It goes over an arming or power toggle or rocker on a robot, RC or marine control panel. The 44 x 50 x 3 mm base plate has an 18 x 34 mm window for the switch body and nut, and four 3.4 mm M3 clearance holes placed outside the lid. The hinged 24 x 46 mm lid leaves 19 mm of headroom above the plate for the lever and has a finger lip at the front.
DIN Rail Riser Foot For 2020
A riser bracket that carries 35 mm top-hat DIN rail (TS35) on 2020 aluminium extrusion, so terminal blocks, SSRs and DIN-mount supplies can live on a control frame. The 26 x 50 mm foot bolts into the T-slot with two M5 screws on 30 mm centres, and the 42 x 26 mm saddle sits 20 mm above the extrusion with 35.4 mm side walls that capture the rail lips plus a side-loaded M4 hex-nut pocket and 4.5 mm through hole for the rail screw. Print two or more and span the rail across your frame.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.