Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Screw-On Drywall Outside Corner Guard
A 150 mm tall L-shaped guard that screws over a 90° outside drywall corner. It stops vacuums, strollers and furniture from crushing the corner bead. Each flange is 32 mm wide and 3 mm thick, with a 6 mm bullnose at the corner and a 2 mm relief groove so it sits flat over a raised metal bead. It has five staggered 4.5 mm countersunk holes for #6 (3.5 mm) or #8 (4.2 mm) wood screws, or for screws in plastic drywall anchors.
Clamp-On Table Corner Safety Guard
A childproofing corner guard for tabletops 10–30 mm thick. It covers the corner with a 3 mm cap and 5 mm bumper walls that have a 12 mm radius on the outside. An M4 thumbscrew in a brass heat-set insert (5.5 mm bore) clamps it from underneath, so it stays on where foam bumpers peel off, and it doesn't need drilling or adhesive. The whole guard is 55 x 55 x 55 mm. The under-jaw has 45° ramps, so it prints cap-down with no supports. Use an M4 x 25 screw for thick tops and an M4 x 40 screw for thin ones, and put a felt pad on the screw tip.