Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Abandoned Spigot Wall Blanking Plate
A 110 x 110 mm wall plate that covers the hole left behind when an outdoor hose bib is moved or capped. It covers wall openings up to 68 mm across, and its hollow 45° dome clears a capped pipe stub up to 24 mm OD sticking out 22 mm (wider near the wall). It mounts with four slotted #8 screw holes (4.8 mm, 8 mm of radial adjustment). The back has a caulk-bead groove and a 4 mm weep channel so trapped water drains instead of rotting the siding.
150 mm Oversize Shower Arm Cover Plate
A 150 mm escutcheon plate that slides over a standard 1/2 in IPS shower arm (21.3 mm OD; 22.5 mm bore) and covers a rough wall hole up to about 140 mm across. Most "oversized" plates in stores stop around 100 mm. It prints face-down so the visible face comes out smooth. The 10 mm deep ribbed back reaches over uneven tile, an M4 set screw in the collar grips the arm, and a weep notch at the bottom lets trapped water drain out.
Slotted Towel Bar Old-Hole Cover Rosette
A 100 mm diameter, 4 mm thick rosette plate that sits behind a new towel-bar or grab-bar mounting flange and hides the holes left by an older, wider bar. It has four radial 4.8 mm slots that take #8 or #10 wood screws (4.2 mm / 4.8 mm shank) at any spacing from 20 to 76 mm, horizontal or vertical. It prints face-down so the show side comes out smooth, and it can be painted to match the wall.
Door Knob Bore Hole Cover Plate
A 79 mm cover plate that hides the abandoned knob hole left in a door after a lockset is moved or swapped for a lever. It has eight flex fingers that snap into a standard 2-1/8 in (54 mm) cross-bore and grip about 53–55 mm. Two countersunk 4 mm holes, 66 mm apart, take #6 wood screws for a permanent fit. It prints face-down, so the visible face is the smooth bed side.