Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Six-Lane Crimp Terminal Holding Block
A 70 x 36 x 12 mm bench block with six graduated channels (1.2 to 3.2 mm wide) that hold Dupont, JST-XH/PH and similar small crimp terminals flat and straight while the barrel overhangs the front edge. A 45° undercut gives the lower crimper jaw room to close squarely without bending the terminal. Strip-length holes in the back face (3, 5 and 7 mm deep, 2.4 mm bore) let you gauge stripped conductor length before you crimp.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Seven-Size Wire Ferrule Scoop Tray
A 160 x 80 x 16 mm bench tray with seven 20.7 x 46 mm wells for bootlace ferrules from 0.5 to 6 mm² (0.5/0.75/1/1.5/2.5/4/6). Each well has a 45° scoop ramp at the front so you can slide out a single ferrule, and 1 to 7 notches in the front lip mark the size. A 150 x 25.6 mm trough at the back holds the crimper or flush cutters, so loose ferrule bags don't end up spread across the desk.
Stepped Wire Strip Length Gauge
A bench gauge with eight stepped lanes (5, 6, 7, 8, 10, 12, 15 and 20 mm). Push the wire into a lane until it bottoms out, close the stripper flush on the face, and you get that exact strip length every time, so Powerpole, Dupont and ferrule crimps come out consistent. Each lane has a 4.2 mm bore that takes roughly 20–14 AWG insulation (up to about 4 mm OD) and a 2.4 mm bore for 26–22 AWG hookup wire (up to about 2.2 mm OD). The block is 104 x 26 mm, and each lane's height shows its depth.