Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi 4 Edge-On DIN Rail Snap Mount
This mount holds a Raspberry Pi 4B or 3B+ edge-on to a standard 35 mm TH35-7.5 DIN rail (1 mm flanges). The board sits on four M2.5 standoffs on the 58 x 49 mm hole pattern and stands at right angles to the rail, so it takes up roughly 25 mm of rail instead of 85 mm. On the 92 x 87 mm plate, a fixed hook grips one rail flange, a flexure latch snaps over the other, and you release it by twisting a flat screwdriver in the slot.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
DIN Rail Terminal Block End Stop
Screw-lock end stop / partition barrier for 35 mm top-hat DIN rail (EN 60715 TS35, 7.5 mm hat, 1.0–1.5 mm flange): hooks reach 2.3 mm behind both rail flanges and two M3x16 screws self-tap into 2.6 mm holes to jack the body off the rail and lock it solid, so terminal blocks stop sliding and wires stop pulling at the crimp. 42 mm wide x 35.4 mm tall x 10 mm thick (one block width), with a 10 x 4 mm cable-tie slot at the top for anchoring the wire bundle.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
DIN Rail Riser Foot For 2020
A riser bracket that carries 35 mm top-hat DIN rail (TS35) on 2020 aluminium extrusion, so terminal blocks, SSRs and DIN-mount supplies can live on a control frame. The 26 x 50 mm foot bolts into the T-slot with two M5 screws on 30 mm centres, and the 42 x 26 mm saddle sits 20 mm above the extrusion with 35.4 mm side walls that capture the rail lips plus a side-loaded M4 hex-nut pocket and 4.5 mm through hole for the rail screw. Print two or more and span the rail across your frame.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
DIN Rail Pi Zero Snap Mount
A 66 x 44 mm adapter plate that snaps onto standard 35 mm top-hat DIN rail (TS35) and carries a Raspberry Pi Zero / Zero 2 W on its front face via the 58 x 23 mm hole pattern, plus two spare M3 holes for any other small module. One rigid hook grabs the first rail flange; a 30 mm sprung tongue with a pull tab grabs the second, so boards clip on and off the rail in a second without unscrewing anything — ideal for putting hobby sensors and controllers into a real home-automation or garage panel.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.