Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Deep Drawer Dish Peg Tile For 1/2 in PVC
A 150 x 150 mm tile with nine sockets on a 50 mm grid. Offcuts of 1/2 in schedule 40 PVC pipe (21.3 mm OD) push into the sockets and work as pegs, so you get the adjustable plate-and-bowl peg board for deep kitchen drawers without buying the kit. Each 22.4 mm socket has crush ribs that grip the pipe, a lead-in chamfer and a crumb drain hole, and dovetail tabs let you lock tiles together to fill any drawer.
Over-Sink 8 mm Rod Drying Rack End Rail
This is one end rail for a roll-free over-sink drying rack. Print two and push seven 8 mm stainless rods (or 8 mm dowels cut to sink width plus about 30 mm) into the 8.3 mm sockets on 22 mm centres to bridge the sink. Each rail is 150 x 22 x 14 mm and rests on the sink rim. A 10 mm lip with a 45° chamfer drops inside the basin edge, so with one rail on each side the rack can't slide off. The rack lets you air-dry pans, colanders and produce right over the drain.
Three-Cell Draining Cutlery Caddy
This is a freestanding cutlery basket to replace the one that cracked or went missing from a dish rack. It measures 100 x 70 x 100 mm and has three 31 mm cells for forks, knives and spoons. Water drains through 5 mm holes in the floor into four underfloor channels that open out both sides, and vertical slots in the front and back walls let air through so the cutlery dries instead of sitting in a puddle.