Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Dishwasher Drain Hose High-Loop Saddle
This saddle screws to the inside wall of a sink cabinet. It holds the dishwasher drain hose in a code-style high loop around a 40 mm radius so the hose can't kink, sag or siphon. A 26 mm wide grooved channel takes corrugated drain hose from about 16 to 25 mm OD, and two zip-ties per station pass through slots in the core. The 140 x 60 x 49 mm flange takes three #8 wood screws through 5 mm clearance holes.
Dishwasher Pod Gravity Dispenser
This is a gravity-feed dispenser for dishwasher detergent pods that screws to the inside of a sink-cabinet door. You load pods from the open top and pull them out one at a time from the bottom slot. A 3 mm lip stops the bottom pod from sliding out when the door swings. The chute is 50 mm wide and has 40 mm of depth under the 45° front lips, so pods up to about 48 x 38 mm of any thickness fit. It holds 6–7 pods in a 55 x 160 x 54 mm body. It prints flat on its back with no supports and mounts with two #8 (4.2 mm) pan-head screws through 4.5 mm holes. Pods are a poisoning risk, so mount it high inside a child-latched cabinet.
Dishwasher Slotted Countertop Mount Bracket
This replaces the snapped anchor tab that keeps an under-counter dishwasher from tipping forward when you pull out a loaded rack. It is a gusseted L-bracket, 55 x 45 mm and 22 mm wide, with 4.5 mm legs. Each leg has a 5 mm slot about 20 mm long that takes #8 (4.2 mm) or #10 (4.8 mm) screws, so it lines up with the dishwasher's existing frame hole and with the underside of the countertop or the cabinet side.
Dishwasher Rack Roller Wheel Clip
Replacement upper-rack roller for a dishwasher, with a print-in-place 22 mm wheel (7 mm tread, 27 mm retaining flange) that spins on a captured 8 mm post. Instead of copying a model-specific axle stud, the carriage snaps sideways onto any round rack wire from 4.5 to 5.2 mm diameter (5.6 mm pocket behind a 4.4 mm snap mouth), so it works on older machines where the OEM roller is only sold bundled with a whole rack. Overall 40 x 28 x 22 mm; print in PETG rather than PLA for dishwasher wash temperatures.
Dishwasher Rack Tine Repair Clamp
A screw-clamped replacement tine for a dishwasher rack: a split saddle grips any coated rack wire from 4.6 to 6.6 mm and carries a 48 mm tapered fin that holds plates apart where the original tines snapped or rusted through. 59 x 21 x 36 mm, closed by two M3 x 20 stainless screws into M3 heat-set inserts (4.0 mm bores), with six drain cutouts; print in PETG.