Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Fridge Door Bin Clip-On Bottle Divider
A divider that clips onto the top edge of a fridge door bin and splits it into bays, so bottles and jars stop sliding and tipping every time the door swings. It has a 70 x 61 mm ribbed fin and a sprung outer jaw that grips any bin wall from 2 to 6 mm thick. The finger flexes in the print plane, so it won't snap along layer lines.
Six-Cell Utensil Crock Divider Insert
A drop-in insert that splits a round utensil crock into six cells plus a 13 mm centre tube. It stops spatulas, whisks and tongs from tangling into one jammed bundle. It is 96 mm across and 100 mm tall, so it fits any crock with an inside diameter of 100 mm or more. The top edges slope down toward the rim so utensils slide in easily, and bridged notches at the foot of each fin let rinse water drain between the cells.
Divided Wide Pegboard Bin
A four-column open-top bin for standard 1/4 in pegboard (6.35 mm holes on a 25.4 mm grid), 100.8 W x 80 D x 70 H. It is part of the '1/4 in Pegboard Locking-Peg Tool Wall' kit. It hangs on two of the kit's printed octagonal hook pegs at X ±38.1 mm and is held by two split, ridged lock pins placed 25.4 mm below the hooks. The 5 mm back plate is flat behind, and the back plate and 3.6 mm front wall carry 2.9 x 1.5 mm grooves at X = −25.4, 0 and +25.4 for the kit's 2.0 mm slide-in dividers.
Cabinet Sheet Pan Divider Rack
A screw-down cabinet divider that stands sheet pans, cooling racks, muffin tins and cutting boards on edge in four graduated slots — 12, 18, 24 and 30 mm wide — so you pull one out without unstacking the pile. Overall 96.5 x 80 x 64 mm, with a 24-to-64 mm sloped fin profile for easy grabbing and four counterbored 4.6 mm holes (flush heads, 9 mm x 2.5 mm counterbore) for #8 wood screws or M4 bolts into the shelf.
Tension-Lock Adjustable Drawer Divider
A print-in-place two-piece drawer divider: a 44 mm tall blade slides in a captured T-channel and locks at any width from 171 mm (as printed) to about 229 mm with a single M4 x 12 thumbscrew threading into a 3.4 mm self-tap boss. Molded end ribs bite the drawer sides so it stays put in utensil, desk and nightstand drawers without adhesive or cutting.