Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flex-Fin Door Edge Pinch Guard
A C-shaped guard that pushes onto the edge of an interior door. Its hollow 22 mm spacer block hits the jamb before the door can shut, so it can't pinch fingers or slam, and it holds a pet gap open. Four 1.7 mm flex fins inside the 43 mm jaw grip door leaves from 34 to 41 mm thick (1-3/8 in and 1-5/8 in doors) without screws. The part is 54 x 47 x 30 mm.
Print-In-Place Kickdown Door Holder
A gravity kickdown door holder that prints in one piece. It has a 40 x 58 mm plate with four 5 mm slots for #8 or #10 wood screws, a fixed 5 mm hinge pin and an 18 mm wide, 80 mm long arm with a serrated foot. Stowed, the arm points up and leans back against the door. Kick it down and it swings over the plate. Mount the plate's lower end about 15 mm above the floor and the arm wedges at roughly 24° to hold the door. The slots give 10 mm of height adjustment, and the holder works whatever the gap under the door is.