Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Label-Window Drawer Pull
A finger pull and slide-in label holder, part of the '2020 Gridfinity Drawer Tower' kit. It has a 124 x 36 x 4 mm backplate and a 16 mm deep tapered lip. Two M3x14 screws go through its 3.4 mm holes at ±55 mm and the Drawer Front Panel and into the tray's self-tap pilots, so your pull lands on the tray. An 84 x 14 mm window shows an 86 x 18 mm card up to 0.8 mm thick, which slides into a 1 mm back slot that is open at the top.
Slotted 64-96 mm Desk Drawer Pull
This is a 130 x 34 x 18 mm replacement bar pull for desk drawers and file cabinets that lost a handle whose exact hole spacing nobody sells anymore. Each foot has a 4.5 mm slot with a sliding M4 nut channel (7 mm across flats) behind it, so one pull fits any centre spacing from 64 to 96 mm, including 64 mm, 3 in (76.2 mm), 3.5 in (88.9 mm) and 96 mm. It prints on its side, so pulling on the handle loads it along the layers instead of across them.