Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
32/64/96 mm Drawer Slide Spacer Block
This is a ribbed 32 x 64 x 96 mm spacer block for installing drawer slides. It sets the slide 32, 64 or 96 mm above the cabinet floor, depending on which face it rests on, so you can screw the slide down level without measuring each one. A V-groove 37 mm from one end lets you mark the usual 37 mm 32 mm-system setback from the cabinet front. The block is hollow, with a centre rib and 3 mm walls, so it uses about 60 cm³ of plastic.
Twin-Detent Drawer Runner
Part of the '2020 Gridfinity Drawer Tower' kit. This 135 x 20 x 16 mm side rail bolts to the inner slots of a front and a back 2020 post with two M5x10 socket-head screws and drop-in T-nuts. The 5.5 mm holes sit 115 mm apart and have 10 x 5.5 mm counterbores, so the heads end up below the face. A 6 x 5 mm ledge carries one side of a Gridfinity tray. Two 0.8 mm half-round ridges click into the tray's notches. The ledge ends have 1.5 mm lead-in chamfers. The part is symmetric, so all 8 runners are identical.
Drawer Slide Rear Socket Bracket
A rear-mount socket that captures the back end of a 45 mm tall x 12.7 mm wide ball-bearing drawer slide where the cabinet has no rear rail — the pocket is 46 x 13.4 mm with a flared mouth so the slide drops in, and an M4 self-tapping set screw locks it. The 88 x 40 x 5 mm back plate takes two #8/M4 wood screws plus two 12 mm vertical adjust slots for height alignment; overall 88 x 40 x 43 mm.