Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
E-Bike Display 22.2 mm Bar Clamp Cradle
This is a split pinch clamp for 22.2 mm (7/8 in) e-bike and e-scooter handlebars. It has a 68 x 24 mm mounting face that replaces the cracked stock clamp on an LCD display, throttle display or small controller. The face has slotted M4 holes that fit hole spacings from 30 to 48 mm, plus two zip-tie slots for brackets with no holes. It closes with one M4 bolt into a captured nut and can be rotated on the bar to set the display tilt.
E-Bike Downtube V-Saddle Battery Mount
An 84 x 60 mm saddle with a 90° V-groove that centres on any round bike downtube or frame tube. It holds a battery tray, bag plate or bottle cage on a frame that has no bosses. Two 20 x 3 mm strap tunnels take hose clamps or Velcro straps, and four 5.5 mm M5 clearance holes on a 66 x 38 mm pattern bolt your accessory to the flat base.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
21700 Three-Cell Strap-Down Cradle
A strap-down cradle for three 21700 cells lying side by side. It's for power banks, e-bike packs and high-drain flashlight builds, where almost every printed holder is sized for 18650s. It has two 22.4 mm saddles on a 25 mm pitch, so 21.0–21.7 mm cells drop in with 2.6 mm walls between them. The open ends take cells of any length, including 76 mm protected cells. Slots for a 20 mm hook-and-loop strap and four 4.5 mm M4 holes are on a 108 x 60 mm base.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.