Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Venturi Vacuum Gripper Head
A pick-and-place vacuum head that bolts straight to an MGN12H carriage (20 x 20 mm M3 pattern) and clamps a 4 mm OD PTFE/Bowden vacuum line in a split barrel pinched by a single M3 bolt with a captured nut. A Ø10.5 mm counterbore at the bottom seats a suction-cup collar, and a Ø22 mm scallop with two 4.5 mm zip-tie slots cradles the venturi ejector body alongside. Overall 52.5 x 29 x 52 mm.
Fin Ray Compliant Gripper Finger
A Fin Ray-style compliant gripper finger, 94 mm long × 30 mm deep × 22 mm wide, with a 3 mm contact beam, a 3 mm tapered spine and six 2.6 mm cross ribs, so the face wraps around whatever it touches instead of point-loading it. It bolts to any jaw carrier with two M3 socket screws on a 14 mm spacing through counterbored 3.4 mm holes (5.5 mm heads sink 12 mm deep); the part is mirror-symmetric, so print two identical fingers for a two-jaw gripper.