Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pinned Cleat Rail End Stop
End stop for the 'Printed French Cleat Bin Wall' kit. It is a 20 x 55 x 13 mm block that butts against the end of a 200 mm cleat rail and sits 10 mm above the rail's 45 mm front and 8 mm in front of it, so hangers can't slide off the end. It takes two 4 mm x 20 mm steel dowel pins in 4.3 mm x 11 mm blind holes at d=6, h=10/25, which you can glue with CA. The block is symmetric, so turn it over to use it at the other end of the row.
DIN Rail Terminal Block End Stop
Screw-lock end stop / partition barrier for 35 mm top-hat DIN rail (EN 60715 TS35, 7.5 mm hat, 1.0–1.5 mm flange): hooks reach 2.3 mm behind both rail flanges and two M3x16 screws self-tap into 2.6 mm holes to jack the body off the rail and lock it solid, so terminal blocks stop sliding and wires stop pulling at the crimp. 42 mm wide x 35.4 mm tall x 10 mm thick (one block width), with a 10 x 4 mm cable-tie slot at the top for anchoring the wire bundle.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.