Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
150 mm Oversize Shower Arm Cover Plate
A 150 mm escutcheon plate that slides over a standard 1/2 in IPS shower arm (21.3 mm OD; 22.5 mm bore) and covers a rough wall hole up to about 140 mm across. Most "oversized" plates in stores stop around 100 mm. It prints face-down so the visible face comes out smooth. The 10 mm deep ribbed back reaches over uneven tile, an M4 set screw in the collar grips the arm, and a weep notch at the bottom lets trapped water drain out.
Hinged Grab Bar Flange Cover 1-1/4 in
This is a replacement for the snap-on cover over the screws of an ADA grab bar flange. It is a clamshell with a hinge printed in place, so it swings open and closes around a 1-1/4 in (31.75 mm) grab bar that is already installed, and one M3 screw and nut lock it shut. The cover is 88 mm across and 44 mm tall. Inside, it hides round wall flanges up to about 80 mm across and 12 mm deep. The 32 mm collar grips the tube when the screw is tightened.
Jumbo Shower Valve Cover Plate
A 176 mm round shower valve trim plate with a 12 mm skirt. It covers wall cutouts up to about 165 mm across, which is too big for any stock escutcheon. The plate has a 65 mm centre opening for the valve body. Two slots take #8 screws (4.6 mm wide) at any spacing from 74 to 102 mm centre-to-centre. Eight radial ribs keep the face flat, and a weep notch at the bottom lets water drain out.
Snap-In Sink Hole Cover Plug
A snap-in cover plug for the standard 1-3/8 in (34.9 mm) faucet or side-sprayer hole left open in a sink or countertop after a faucet swap. A 50 mm diameter flange hides the hole and six 45 degree ratchet fins on six flexing legs grip deck thicknesses from about 5 mm to 28 mm; overall 50 mm across and 33 mm tall, printed visible-face-down so the show face comes off the plate smooth.
Split Shower Arm Escutcheon Flange
An oversized 78 mm split escutcheon that clamps onto a 1/2 in NPS shower arm (21.3 mm OD) to hide the chipped drywall or tile hole left after an arm swap — the stock 50 mm flange never covers it, and you can't buy a split one without a whole arm kit. It prints as one piece: a 1.2 mm living-hinge ligament at the rim lets the two halves swing open around the arm in place, then one M3x20 screw through the 3.4 mm lug into the 2.6 mm self-tap pilot pulls the 21.8 mm bore tight. 78 mm dia x 16 mm tall, 2.6 mm brim, print in PETG.