Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Eurorack 8HP Ribbed Blanking Panel
This blanking panel follows the Doepfer A-100 3U spec: 128.5 mm tall, 40.3 mm wide (8HP) and 2 mm thick, with M3 slots on rail centres 122.5 mm apart. Use it to close gaps in a Eurorack case. Ribs on the back keep the plate stiff and stay clear of the rails, and the 6 mm slots make up for rail nut positions that don't land exactly on the HP grid.
Eurorack 3U Rail End Bracket
This L-shaped side bracket turns a plywood box into a Eurorack 3U case. Its two vertical 5.5 × 16 mm slots are 122.5 mm apart, matching the 3U panel hole pitch, and they take an M4 or M5 rail-end screw with ±5 mm of adjustment, so different rail profiles still line up. You screw it to the case floor and side with #8 wood screws (4.8 mm holes). It is 155 mm tall and 30 mm deep, and it prints lying on its L profile so rail loads run along the layers.