Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Parts Drawer Slide-In Label Windows
A set of four slide-in label windows for the fronts of plastic parts-cabinet drawers (Akro-Mils, Stack-On, Harbor Freight style), printed together and snapped apart. Each one is 56 x 22 x 4 mm and holds a 46 x 16 mm card cut from an index card, with a 45 x 12 mm window, which is enough for a two-line spec like "M8 x 20 – 1.0". Stick it on with double-sided foam tape, so it fits any drawer front 22 mm or taller. A thumb notch lets you push the card out when you restock the drawer.
Hang-Down M3-M5 Cap Screw Rack
A 150 x 66 x 48 mm stand for socket head cap screws. They hang by their heads through three rows of oversized clearance holes: 12 × M3 (3.4 mm), 10 × M4 (4.5 mm) and 8 × M5 (5.5 mm). Because the screws hang side by side, you can compare their lengths at a glance instead of digging through a tray. The stand has 44 mm of clearance under the deck, so screws up to 40 mm long hang free. It prints with the flat deck face on the bed and the legs pointing up, then you flip it over to use it.
#6 #8 #10 Wood Screw Stand-Up Caddy
A 124 x 60 x 34 mm bench caddy that holds 24 wood screws point-down in three gauge zones, eight holes each: #6 (3.5 mm shank, 3.9 mm hole), #8 (4.2 mm, 4.6 mm hole) and #10 (4.8 mm, 5.2 mm hole). The heads sit on the deck so you can pick up the next screw straight away instead of digging through a pile. Screws up to about 30 mm long hang in a closed cavity. One, two or three notches on the front edge mark each gauge, and internal ribs keep every deck bridge under 19 mm.
Print-In-Place Hinged Eight-Bay Parts Case
A pocket case for small parts, 100 x 64 mm and 22.4 mm tall when closed. It has eight bays of about 22 x 29 x 16 mm, sized for screws, nuts, crimp terminals or the spare clips from a repair job. The lid prints lying flat next to the box on a 4 mm pin hinge that comes off the bed already assembled. A locating rim under the lid drops into the box mouth, sits 0.5 mm clear of the dividers so bays stay separate, and a front tab lifts it open.
M3 To M8 Washer Tube Rack
Wall or bench rack with five coin-tube wells sized to real DIN 125 form-A flat washers — bores 7.8, 9.8, 10.8, 12.8 and 16.8 mm for M3 (7 mm OD), M4 (9), M5 (10), M6 (12) and M8 (16) — each with a front slot to see and thumb-push the stack and 52 mm of usable stack depth (about 32 M8 or 100 M3 washers). 74 x 69 x 26 mm overall; a 3 mm front shelf catches washers you pull out, 1 to 5 tally notches in the front lip name each bore, and two 4.5 mm M4 clearance holes 52 mm apart in the top rail sit clear of the tubes for a driver.