Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Cam-Lock Housing And Bolt Rebore Jig
An L-shaped drilling jig for moving a blown-out flat-pack cam lock to fresh wood on an 18 mm panel. The 8 mm guide plate takes a 15 mm Forstner bit, and the edge fence lines up an 8 mm bit so the bolt hole meets the housing at mid-thickness (9 mm down). It has two stations: the housing centre sits 24 mm or 34 mm in from the panel edge. Overall size is 90 x 58 x 28 mm.
Flat-Pack 8 And 10 mm Dowel Sprue
A snap-off sprue of eight replacement furniture dowels: four 8x30 mm, two 8x40 mm and two 10x40 mm. They replace lost or snapped wooden pegs when you re-assemble IKEA-style flat-pack furniture. The dowels print lying flat so the layer lines run along the peg and it doesn't shear across a layer. The flat top and bottom faces leave a glue-relief channel, and the chamfered ends help them start in the hole. The 95 x 54 mm frame also has 8.0 and 10.0 mm test bores so you can check the fit before you glue.
Eccentric Cam Panel Draw Connector
This is a two-piece, print-in-place, surface-mount connector that replaces a stripped flat-pack cam lock. It does not need the old cam hole. The 27 mm eccentric cam turns on a #8 (4.2 mm) wood screw driven into panel A. The cam sits captured under a 45° lip in a 72 x 40 x 7 mm keeper, which is screwed to panel B through slotted #8 holes. A half-turn of the cam's 19 mm hex pulls the joint 6 mm tight, and the cam locks past dead centre.
Straddle Cam Lock Desk Repair Bracket
This inside-corner bracket is 80 mm long with 36 mm legs. It repairs flat-pack desk joints where the cam lock has stripped or torn out. A 24 x 14 mm window at the centre fits over the old cam housing and any crumbled chipboard. Four slotted #8 wood-screw holes (4.8 mm wide with 9 mm counterbores) sit 26 mm from the corner so the screws go into undamaged wood, and 6 mm end gussets keep the joint square.
Flat-Pack Furniture Hardware Keeper
A 150 x 90 x 22 mm tray that keeps a flat-pack furniture kit together through a move. It has three scoop bays for cam locks, bolts and hex keys, a rack of seven 8.6 mm sockets that hold 8 mm dowels upright, and a rack of nine 5.4 mm sockets for standard 5 mm shelf pins. Two 4.5 mm holes in the floor take #6 or M4 screws, so you can fix it inside the wardrobe or drawer it belongs to.
Flat-Pack Desk Anti-Wobble Corner Brace
A 70 x 70 x 36 mm gusseted L-brace that screws into the inside corner where a flat-pack desk top meets its side panel. It stiffens the joint once the cam locks work loose and the desk starts to rack. Each 5 mm leg has two 4.8 x 8 mm slots that take #8 (4.2 mm) or #10 (4.8 mm) pan-head wood screws, so you can line it up without new pilot holes. Use 5/8 in screws in 16–18 mm particleboard.