Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Sump Pump Float Cord Zip-Tie Pipe Clamp
Replaces the small plastic clip that snaps off and lets a tethered float switch cord slide down the sump discharge pipe. A 90° V-saddle seats any pipe from 1-1/4 to 2 in (42–60 mm OD), and two zip-tie tunnels lock it to the pipe. A 10 mm top groove with two more tunnels grips float cords up to about 9 mm, so you can set the tether length by sliding the cord before you cinch it. The clip is 40 x 60 x 40 mm and takes standard ties up to 4.8 mm wide.
Three-Pivot Dehumidifier Float Lever
This replaces the cracked float arm in a dehumidifier bucket. A broken arm stops the unit from running even when it still works. The lever is 162 mm long with a sealed hollow float (40 x 24 x 14 mm, about 13 g of lift). It has three 3.4 mm pivot holes 10 mm apart that take a 3 mm steel pin or an M3 screw, so you can choose the lever ratio, and a 12 mm tall switch flag you can trim to the length you need.