Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Air Fitting And Hose Coupler Sort Block
A 148 x 118 mm tray with 11 thread-down cups for loose brass fittings. There are four 15 mm cups for 1/4" NPT plugs and couplers (thread OD 13.7 mm), four 18.5 mm cups for 3/8" NPT (17.1 mm) and three 28 mm cups for 3/4" garden-hose GHT fittings (about 26.5 mm). The bores are oversize so slightly different brands still fit. Each fitting stands on its threads with the hex body sitting on a chamfered rim, so the drawer full of mixed couplers becomes one tray you can read at a glance.
Hose And Pipe Thread ID Gauge Card
A 150 x 60 x 3 mm gauge card that identifies a hose or pipe thread. It has four 60-60 mm thread combs: 11.5 TPI (2.21 mm, used by garden hose GHT and 1" NPT), 14 TPI (1.81 mm, 1/2" and 3/4" NPT/BSP), 18 TPI (1.41 mm, 1/4" and 3/8" NPT) and 1.5 mm metric (M22 pressure washer). Three U-notches check male thread OD: 21.6 mm for 1/2" NPT, 27.3 mm for 3/4" NPT/GHT and 33.7 mm for 1" NPT. With it you can tell which adapter to buy before you go to the hardware store.
Garden Hose Split Repair Clamp
A print-in-place clamshell sleeve that seals a split, pinhole or kinked spot in a garden hose without cutting it — fold it over the damage, lay a scrap of inner tube in the 32 x 8 mm pad recess, and tighten two M5 x 30 bolts into the captured M5 nuts. The 45° vee channel closes to a 16 mm tall aperture with a 10 mm flat, so it grips 1/2" and 5/8" hose (16–22 mm OD) without necking the bore down like a barbed splice; part is 50 mm long and prints open at 88 x 50 x 16.5 mm with an integral 5 mm hinge pin.
Garden Hose Coil Wall Hanger
A gusseted wall hanger that holds a coiled 50 ft / 5/8 in garden hose (about 7 kg wet) on an 88 mm horn raked 13° upward with a 19 mm end lip so the coils cannot slide off. Mounts with three M5 or #10 screws (5.5 mm clearance holes at 9, 22 and 98 mm up the plate, each with a 10 mm x 3 mm head recess); overall 95 x 122 x 16 mm, printed on its side so the load runs along the layers instead of across them. Print in PETG or ASA for UV life.