Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Gas Strut 10 mm Ball Socket End
Replacement snap-on socket end for a gas strut whose plastic cup broke, so a good strut goes back to work instead of in the bin. The slotted cup takes a standard 10 mm ball stud (10.4 mm spherical seat, 9.5 mm snap throat, V-groove for a zip tie or the original wire clip); the 7.2 mm bore self-taps onto the strut's M8x1.25 rod stud with 20 mm of engagement, locked by an M4 set screw through the side. 20 mm barrel with 17 mm wrench flats, 32.5 mm tall — print in PETG if you can.
Gas Strut Sag Stop Clamp
A split collar that clamps onto the exposed 8 mm chrome shaft of a gas lift support so a tired hatch, hood, toolbox lid or camper door cannot sink shut — an 8.4 mm slip-fit bore, a 28 mm flange that bears flat on the strut's gland, and two M3 pinch bolts with captured M3 nuts (5.7 mm hex pockets). 36 mm tall overall, printed shaft-axis-vertical so the load is compression through the layers, not peel.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.