Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Strap-On Garage Remote Visor Clip
Replaces the snapped spring clip on a garage or gate remote. You strap it to the remote's back through two 22 x 3.5 mm slots (one 20 mm hook-and-loop strap or a pair of zip ties), so it fits any remote shell. A tapered flex tongue opens from a 10 mm pinch to about 23 mm, so it clamps onto most car sun visors. The part is 75 x 37 x 40 mm and prints on its side, so the tongue flexes along the layers instead of across them.
Gate Opener Post Pivot Bracket
A chunky replacement post-pivot bracket for a swing-gate opener arm: an 88 x 48 mm backplate that covers the full 3.5 in face of a 4x4 wood or vinyl post, four 5.5 mm holes (M5 / #10 lag screws) on a 56 x 24 mm pattern, and a 18 mm thick tongue with an 8.3 mm vertical bore for an 8 mm / M8 pivot pin 24 mm off the post face. Printed on its back so every layer line runs across the pull direction, with twin 45 degree webs tying the tongue into the plate — it replaces the cast aluminium bracket that snaps or strips out of a Mighty Mule / Ghost Controls style kit.