Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Patio Chair Stepped Drain Glide Cap
This slip-on foot cap fits outside the leg of a metal patio chair or table and replaces sun-cracked glides. Its stepped socket takes 1 in (25.4 mm) round tube in the upper section and 7/8 in (22.2 mm) round tube in the lower section. Crush ribs give a tight grip whatever the tube wall thickness, and the wide 40 mm pad protects the deck. A 5 mm drain hole and cross channels underneath let rainwater out, so it doesn't sit in the leg and cause rust.
Fridge Crisper Drawer Lip Repair Glide Shoe
A 60 mm bolt-on J-profile shoe that replaces the snapped-off runner lip on a fridge crisper or freezer drawer side wall (Whirlpool, Kenmore, Frigidaire style clear drawers) so the drawer stops tipping and falling off its rail. The inner plate bolts to the inside of the drawer wall with two M3x10 screws and nuts through 3.4 x 10 mm vertical slots (6.6 mm of height adjustment to match the original lip), the 8 mm channel hooks over any wall up to 5 mm thick with room for the nut, and a 9.4 mm wide glide ledge hangs 6.6 mm below the bridge to ride the liner runner; print in PETG and drill two 3.5 mm holes through the drawer wall using the slots as a guide.
Office Chair Caster Stem Glide Foot
Fixed glide foot that drops into an office chair base in place of a rolling caster, for the standard 7/16 in x 7/8 in (11 x 22 mm) grip-ring stem socket; the 10.2 mm stem carries four crush ribs to 11.4 mm so it presses tight into 11.0–11.3 mm sockets (not 10 mm Euro stems). The 50 mm diameter, 14 mm tall pocketed foot has a flat bottom for a stick-on felt pad and a 36 mm overall height; print five to stop a chair rolling on hard floors.