Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Stackable 1.5° Grab Bar Flange Taper Shim
An 84 mm round tapered shim, 2.0 mm thick on one edge and 4.2 mm on the other, giving 1.5° of correction. It goes behind a grab-bar flange (up to about 3 in across) on an out-of-plumb or bowed tile wall so the bar sits square and doesn't rock. Three 5.5 mm radial slots cover screw circles from 48 to 68 mm and clear #10 (4.8 mm) screws. A V-notch marks the thick edge, so you can stack two shims with the notches lined up for 3°, or turn one to point anywhere you need.
1-1/4 in Grab Bar Toilet Roll Arm
This U-saddle drops onto a standard 1-1/4 in (31.75 mm) grab bar and is locked in place by an M4 screw. It carries a 115 mm cross-fin spindle that sits 80 mm off the bar axis, so a standard roll (42 mm core, up to about 120 mm OD) hangs clear of the bar and the wall. It lets you put the toilet paper where a seated user can reach it, with no new holes in tile and no need to trust a second set of wall anchors.
1-1/4 in Grab Bar Saddle Soap Dish
This soap dish snaps onto a standard 1-1/4 in (31.75 mm) shower grab bar, so you don't have to drill new holes in the tile. The clip has a 32.2 mm bore and wraps 240° around the bar at both ends. The ribbed 72 x 80 mm tray sits directly above the bar, so the soap's weight doesn't twist it. Six drain slots let water run straight down onto the bar.
Hinged Grab Bar Flange Cover 1-1/4 in
This is a replacement for the snap-on cover over the screws of an ADA grab bar flange. It is a clamshell with a hinge printed in place, so it swings open and closes around a 1-1/4 in (31.75 mm) grab bar that is already installed, and one M3 screw and nut lock it shut. The cover is 88 mm across and 44 mm tall. Inside, it hides round wall flanges up to about 80 mm across and 12 mm deep. The 32 mm collar grips the tube when the screw is tightened.
Slotted Towel Bar Old-Hole Cover Rosette
A 100 mm diameter, 4 mm thick rosette plate that sits behind a new towel-bar or grab-bar mounting flange and hides the holes left by an older, wider bar. It has four radial 4.8 mm slots that take #8 or #10 wood screws (4.2 mm / 4.8 mm shank) at any spacing from 20 to 76 mm, horizontal or vertical. It prints face-down so the show side comes out smooth, and it can be painted to match the wall.
1-1/4 in Grab Bar Snap-On Towel Hook
A snap-on J-hook that clips onto a standard 1-1/4 in (31.75 mm OD) shower or tub grab bar. It gives you a place to hang a loofah, washcloth or razor strap without drilling tile. The C-clip has a 32.2 mm bore and a 27 mm snap mouth and is printed flat, so the clip flexes in the strong layer plane. The part is 16 mm thick, about 83 mm tall and weighs about 12 cm³.