Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
E-Bike Display 22.2 mm Bar Clamp Cradle
This is a split pinch clamp for 22.2 mm (7/8 in) e-bike and e-scooter handlebars. It has a 68 x 24 mm mounting face that replaces the cracked stock clamp on an LCD display, throttle display or small controller. The face has slotted M4 holes that fit hole spacings from 30 to 48 mm, plus two zip-tie slots for brackets with no holes. It closes with one M4 bolt into a captured nut and can be rotated on the bar to set the display tilt.
17-23 mm Slotted Handlebar End Plug Trio
This is a set of three bike handlebar end plugs joined by snap-off tabs. They fit bars with an inner diameter of 17–19, 19–21 or 21–23 mm, and the caps are 26, 28 and 30 mm across. Each plug has a 25 mm hollow shank split into four flexing fingers with barbed rings. That gives a snug push-in fit when an old or unusual bike has lost its end cap and you only need one plug.
Handlebar Accessory Extender Bar Clamp
A split clamp for a 31.8 mm handlebar that carries a second 22.2 mm accessory bar stub 55 mm out to the side, so lights, a GPS, a bell and a phone mount stop fighting for stem space. Closed by two M5 bolts with captured nuts, 99 x 44 x 55 mm, gusseted web under the stub.