Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Split Loom V-Saddle Screw Mount
A one-size screw-down saddle for routing split-loom wire harnesses. Its 90° V-cradle is 20 mm wide and 10 mm deep and centres any loom from 6 to 25 mm OD. Two 5.5 x 2.4 mm tunnels under the cradle take zip ties to strap the loom down, so you don't need a multi-pack of P-clips to get the one size you want. The footprint is 60 x 40 x 16.5 mm. The two 4.5 mm holes on 44 mm centres take #8 wood screws (4.2 mm shank) or M4 bolts, for car, boat, garage or control-panel wiring.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Relay And Fuse Zip-Tie Mount Base
A 106 x 52 x 6 mm mounting base (142 mm overall with the screw feet) that gives automotive relay sockets and inline fuse holders something to bolt to instead of dangling off the loom. Two 33 mm bays between 3 mm divider ribs take 4- and 5-pin relay sockets, a 45 degree V-saddle bay cradles round inline fuse holders from roughly 8 to 16 mm, each bay has a pair of 8 x 3.2 mm slots plus a recessed underside channel so a 4.8 mm zip tie loops over the part without lifting the base off the panel, and the two ears carry 4.5 mm M4 clearance holes for firewall or bulkhead screws.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.