Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Size Alligator Clip Boot Sprue
A snap-off sprue of four tapered slip-on insulating boots to replace the cracked rubber boots on alligator and crocodile clip test leads. Jaw-end openings are 7x5, 10x7, 14x10 and 18x12 mm, the boots are 22, 28, 36 and 44 mm long, and the wire holes are 3.0, 3.6, 4.5 and 5.5 mm. Each boot has a finger-stop flange, so you can re-boot your clip leads without buying a whole new set. Measure your clip's handle and pick the boot just over that size. Print in TPU if you want a softer boot.
Electric Fence Corner Post Insulator
A wrap-around corner insulator for electric fencing: an L-block that hugs the 90° corner of a wooden or composite post (34 mm of bearing on each face, 9 mm thick) and carries the hot wire 46 mm clear of the corner on a 26 mm grooved spool. Eight-millimetre corner relief clears a chamfered or rounded post edge, and four 5.5 mm bores take #10 or M5 lag screws, two per face, at mid-height.