Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Six-Lane Crimp Terminal Holding Block
A 70 x 36 x 12 mm bench block with six graduated channels (1.2 to 3.2 mm wide) that hold Dupont, JST-XH/PH and similar small crimp terminals flat and straight while the barrel overhangs the front edge. A 45° undercut gives the lower crimper jaw room to close squarely without bending the terminal. Strip-length holes in the back face (3, 5 and 7 mm deep, 2.4 mm bore) let you gauge stripped conductor length before you crimp.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Twin Pinch-Jaw Connector Depinning Handle
A 110 x 12 x 9 mm handle with a split pinch jaw at each end. Each jaw clamps a steel sewing needle, a guitar string offcut or a flattened pin, anywhere from 0.4 to 1.2 mm thick, using an M3 x 12 screw and a nut held captive in the side. You can set up one end for JST/Dupont latch release and the other as a pin pusher, so you can re-pin harnesses without buying an extractor kit. Its 1.2 mm slit closes on the steel, so you file the tip to suit your connector instead of guessing a pin gauge.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.