Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Kids Light Switch Slide Extender
A print-in-place slide extender that mounts under the two screws of a standard US single-toggle wall plate (60.3 mm / 2-3/8" screw spacing, 6-32 screws through 4.5 mm holes). A captured 22 mm wide slider with a 12 x 14 mm toggle window and a pull tab 78 mm below the toggle lets small kids reach the switch.
Zip-Tie Faucet Spout Extender
A catch-and-channel trough that hangs on a bathroom faucet spout (16–28 mm tip, held by two 4.8 mm zip ties through the jaw slots) and throws the stream about 70 mm forward, so small kids can reach the water and tall bottles fill without hitting the spout. 100 x 40 x 40 mm, self-centering 60° V jaws, 3 mm walls and a sloped 2.5–4.5 mm floor that drains instead of puddling; print in PETG if the tap runs hot.