Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pantry Shelf Can Fence Label Clamp
A 50 mm wide clamp that fits over the front edge of a pantry or cabinet shelf. It adds a 30 mm fence so cans and jars can't roll off, and has a slide-in label channel (1 mm slot, 22 mm visible window) on the front. The jaw opens to 20 mm and an M4 thumb screw in a heat-set insert from below tightens it, so it fits any shelf from 12 to 19 mm thick (5/8 and 3/4 in melamine or plywood) with no drilling.
Breaker Panel 4x6 Directory Card Frame
A slide-in frame that holds a standard 4x6 in (101.6 x 152.4 mm) index card as your circuit directory on the inside of a breaker panel door, so the list stops tearing and falling out when the door swings. The card drops in from the top and sits under two 45° wedge lips, so the frame prints with no supports. Mount it with VHB tape on the flat back, or put M3 or #6 sheet-metal screws through the two 3.4 mm ear holes. The frame is 133 x 157 x 6 mm.
Label-Window Drawer Pull
A finger pull and slide-in label holder, part of the '2020 Gridfinity Drawer Tower' kit. It has a 124 x 36 x 4 mm backplate and a 16 mm deep tapered lip. Two M3x14 screws go through its 3.4 mm holes at ±55 mm and the Drawer Front Panel and into the tray's self-tap pilots, so your pull lands on the tray. An 84 x 14 mm window shows an 86 x 18 mm card up to 0.8 mm thick, which slides into a 1 mm back slot that is open at the top.
Peg-On Drawer Label Holder
A 60 × 20 × 4.5 mm slide-in label frame for the 'Dovetail-Stacking Parts Drawer Cabinet' kit. A 54 × 16 mm paper or card label slides into a 55 × 16.6 × 1.0 mm pocket from the right-hand end and shows through a 50 × 12 mm window. Two split 4.0 mm × 2.3 mm pegs at ±24 mm press into the 4.3 mm holes in the Detent-Stop Parts Drawer front plate, so you don't need glue or tape.
Parts Drawer Slide-In Label Windows
A set of four slide-in label windows for the fronts of plastic parts-cabinet drawers (Akro-Mils, Stack-On, Harbor Freight style), printed together and snapped apart. Each one is 56 x 22 x 4 mm and holds a 46 x 16 mm card cut from an index card, with a 45 x 12 mm window, which is enough for a two-line spec like "M8 x 20 – 1.0". Stick it on with double-sided foam tape, so it fits any drawer front 22 mm or taller. A thumb notch lets you push the card out when you restock the drawer.