Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Strap-On Pool Ladder Step Grip Tread
Strap-on anti-slip tread for above-ground pool ladder steps and deck steps. The pad is 150 x 120 mm with ribs across the step and 72 drain slots. Two pairs of 12 x 3.5 mm slots take heavy zip ties or UV-rated straps around steps up to about 100 mm deep, and the straps sit in recessed channels where feet won't wear them.
Screw-On Ladder Rail Wall Hook
A heavy wall hook for hanging a ladder flat on the garage wall. It has a 92 mm deep cradle and a 32 mm retaining lip, so the side rail of a stepladder or a nested extension ladder drops in and can't roll out. Print two and fix each to a stud with #10 (4.8 mm) screws through 5.5 mm holes. It prints on its side, 150 x 112 x 22 mm, so the weight loads along the layers and the tapered truss arm keeps the plastic volume down.
Bolt-On Ladder Rail Foot Cap
Replacement foot cap for aluminium step and extension ladders with 40 x 20 mm rectangular leg tubing — it slips over the rail end (40.6 x 20.6 mm socket, 27 mm deep) and is held by an M5 bolt through the rail instead of glue, with two 5.5 mm hole heights (14 mm and 24 mm above the ground) so you can reuse the original rivet hole. The 52 x 32 x 7 mm pad has 3 mm deep tread grooves and a 5 mm centre drain, total height 34 mm.