Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Washer-To-Dryer Stacking Foot Cup
A cheaper replacement for the OEM stacking kit: four of these cups go on top of a front-load washer, and each dryer leveling foot drops into a tapered cup (36 mm at the floor, 44 mm at the 12 mm rim), which fits any foot from about 25 to 42 mm across. Each 100 x 60 x 3 mm plate fixes down with two #8 sheet-metal screws through 4.6 mm slots and has a 27 x 4 mm slot for a 25 mm anti-tip strap. The cup walls stop the dryer from walking off the washer.
Clothesline Prop Head For 1/2 in EMT
A 170 mm crossbar head that slides onto a 1/2 in EMT conduit pole (17.9 mm OD, 18.3 mm bore, 36 mm deep), so you can make a clothesline prop. It has four round-bottom line notches at 44 mm spacing to keep up to four lines apart, and an M4 self-tapping lock screw that stops the head from spinning on the pole.
Ironing Board Twin-Hook Wall Hanger
A wall hanger for a folding ironing board: it screws to the wall and has two gusseted J-hooks, 100 mm apart overall, that catch the board's folded leg crossbar. Each hook has a 35 mm deep throat and an 18 mm lip, so leg tubes up to about 30 mm fit. It prints on its side, so the weight pulls along the layers instead of peeling them apart. Three 4.5 mm holes take #8 wood screws or M4 bolts.
22 mm Tube Drying Rack Hinge Half
A split-clamp hinge half for folding laundry and gullwing drying racks with 22 mm steel tube. It clamps on with one M4 bolt and nut, so it can replace a snapped plastic wing hinge. Print two and flip one over: the half-height 12 mm knuckles interleave with a 0.5 mm gap and pivot on an M5 bolt through a 5.5 mm bore. The part measures 53 x 30 x 24 mm. Change T to 19 for 19 mm tube.
Washer Drain Hose Standpipe Clamp
A split collar that clamps onto a 2 in Schedule 40 PVC laundry standpipe (60.3 mm OD) with one M3 x 30 screw and a captured M3 nut, plus a snap-in C-jaw that grips the washer's corrugated drain hose (30–35 mm OD) so it can't kick out of the pipe and flood the room. 113 x 68 x 22 mm, prints flat with no supports and no overhangs.