Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Clamp-On Desk Edge Mouse Wing
A bolt-on mouse platform for shallow desks or keyboard trays. It hooks over the desk edge and extends the surface by 100 mm across a 90 mm wide pad. Two M4 heat-set inserts (5.5 mm bore) in the lower jaw take thumbscrews that clamp desks from 0 to 50 mm thick. A diagonal truss strut stiffens the cantilever, and the part prints on its side so bending loads stay within each layer.
Clamp-On Table Corner Safety Guard
A childproofing corner guard for tabletops 10–30 mm thick. It covers the corner with a 3 mm cap and 5 mm bumper walls that have a 12 mm radius on the outside. An M4 thumbscrew in a brass heat-set insert (5.5 mm bore) clamps it from underneath, so it stays on where foam bumpers peel off, and it doesn't need drilling or adhesive. The whole guard is 55 x 55 x 55 mm. The under-jaw has 45° ramps, so it prints cap-down with no supports. Use an M4 x 25 screw for thick tops and an M4 x 40 screw for thin ones, and put a felt pad on the screw tip.