Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
M5 Bolt-Pivot Fan-Out Sort Tray Tier
A four-cell parts tray (126 x 64 x 22 mm) with a 20 mm pivot boss bored to 5.5 mm. Stack several on one M5 bolt and they fan out sideways like a tackle-box tower, so the cells you aren't using swing back out of the way. Each boss is 24 mm tall, which leaves a 2 mm gap between tray tiers. The whole stack bolts through to a bench or under a shelf, and you set the swing friction by how tight you run the M5 nut.
Drill-Driven Trimmer Spool Winding Cone
A stepped arbor for rewinding string trimmer line with a cordless drill. A 50 mm flange runs into a cone that tapers from 28 mm down to 10 mm, so it centres any spool bore from about 11 to 26 mm. An M5 hex nut (8 mm across flats) sits captive in the base. An M5 x 80 bolt with a fender washer clamps the spool down onto the cone, and you put the bolt head in the drill chuck. The flange also has six check holes for identifying 0.065–0.155 in (1.65–3.94 mm) trimmer line.
M5 Bolt-Through Hummingbird Feeder Ant Moat
A water-filled ant moat that hangs between your hook and a hummingbird or oriole feeder. The 76 mm OD cup is 30 mm deep and has an anti-slosh inward lip. A sealed 14 mm column rises above the waterline and carries an M5 eye bolt through a 5.5 mm bore into a captured M5 nut (8 mm AF) underneath, so the steel takes the feeder's weight and the plastic only holds water.
Screw-Jack Battery Terminal Puller
A two-hook screw-jack puller that lifts stuck car battery terminal clamps. You turn a standard M5 bolt through a captured M5 nut so it presses on the post while the hooks lift the clamp, which is gentler than prying with a screwdriver. The frame is 68 × 61 × 14 mm. The hooks have a 36 mm gap between them, there is a 52 × 38 mm throat for clamps up to about 48 mm wide, and the bolt hole is 5.5 mm. It prints flat, so the pulling load stays along the layers and doesn't split them.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
Screw-Tension Band Clamp 60-68 mm
A T-bolt style band clamp that draws down evenly on anything 60–68 mm OD (2" PVC at 60.3 mm, 63 mm PE pipe, 2.5" dust hose, pond and irrigation hose) using one M5 x 50 bolt and a captured M5 nut in a 5.7 mm across-flats hex pocket. The 14 mm wide, 2.8 mm thick band has a smooth 68 mm bore with no screw slots or sharp tail, so it spreads load without gouging silicone hose the way an oversized worm-drive clamp does; thickened 9 mm end bosses keep the clamping pressure even and the whole 81 x 74 x 14 mm part prints flat with the hoop load in the XY plane.