Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Coiled Keyboard Cable Twin-Saddle Cradle
This desk cradle holds a coiled mechanical-keyboard cable level, so the coil doesn't sag or kink and isn't dragged across the desk. Two U-saddles 29 mm wide fit coils up to about 28 mm OD. A 6 mm keyhole slot on a parking post holds the USB-C end of a 4–6 mm cable by its plug while it's unplugged. The flat base is 150 x 44 mm and the parking post is 48 mm tall.
MX Switch Squeeze-Puller Flexure Tweezer
A one-piece flexure tweezer for pulling MX-style switches out of a hot-swap board. The hooked prongs rest 15.4 mm apart and close to about 9.5 mm before a built-in stop, so they cover the clip tabs on either side of a switch in a standard 14 mm plate cutout. It's 99 mm long and 5 mm thick, and prints flat so the squeeze force runs along the layers instead of across them.
MX Keycap Flex-Jaw Puller
This flat-printed keycap puller has two springy 2.2 mm jaws set 18.6 mm apart, sized for 1u Cherry MX-style keycaps, which are about 18 mm across the base. Sloped teeth open the jaws as you press down over the cap. The 15.6 mm gap between the teeth then catches under the cap's bottom edge so you can pull it straight up without scratching the board. The part is 101 mm long, with a grip bar and a finger ring.
MX Keycap Swap Layout Tray
A 172 x 88 x 7 mm desk tray for swapping mechanical keyboard keycaps. It has 26 pockets sized for 1u MX caps (18.8 mm square, 5.4 mm deep, on a 21 mm pitch) and a 120 mm trench for a 6.25u spacebar, so you can pull caps off row by row and keep them in order. There's an 8 mm push-out hole under each pocket so you can pop caps back out from below.
Two-Bay Upright Keyboard Storage Cradle
A desk cradle that stands two keyboards on their long edge in 42 mm bays, so keyboards up to about 40 mm thick (mechanical boards included) come off the desk surface. The cradle is 99 x 80 mm with 70 mm tapered fins and a 12 x 30 mm cable slot in each bay, so a USB cable can stay plugged in. Print two and set them about a third of the way in from each end of the keyboards.
4x4 MX Switch Tester Board
A 16-switch tester block for mechanical keyboard builders. It has 14.1 mm square cutouts on the standard 19.05 mm key pitch, and a 1.5 mm plate lip so MX-style switches snap in and out without soldering. There is a 16 mm relief pocket under each switch to clear the clips and pins, so you can compare switches side by side before buying a full set. The block is 86 x 86 x 14 mm.