Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Motorcycle Helmet Wall Hook With Jacket Hook
A garage wall hook that holds a motorcycle or bike helmet on a 112 mm arm with a raised lip so the helmet can't slide off. A short hook underneath takes a jacket or gloves. It mounts on a stud with two countersunk #10 or M5 screws through 5.5 mm holes. It prints on its side, which puts the load in the layer plane, and the 45° trussed gusset keeps it stiff with about 90 cm³ of plastic. Overall size is 112 × 135 × 24 mm.
Motorcycle Kickstand Support Pad
A 96 mm diameter load-spreading pad that stops a motorcycle or scooter side stand from sinking into hot asphalt, gravel or soft ground — the printed replacement for the hockey puck riders carry. A 50 mm ID x 12 mm deep cup traps the stand foot so it can't skate off, four drain slots clear water and grit, eight radial gussets carry the load out to the rim, and a 5.5 mm tether hole with a flush knot recess in the base takes paracord or an M5 shackle so it clips to the bike.