Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Probe Oscilloscope Hook-Tip Wall Rack
A 110 x 26 mm wall rack that holds four oscilloscope probes tip-down. Each one sits in a tapered funnel that runs from 17.5 mm across at the top to 8.5 mm at the bottom, so hook-tip caps up to about 8 mm pass through and probe bodies between 9 and 17 mm wide come to rest in the taper. A 2.5 mm fin along the top gives the alligator ground leads something to clip onto, and the rack fixes to a wall or the side of a shelf with two #8 screws through 4.5 mm holes.
Weighted Scope Probe Parking Stand
A 96 x 62 x 34 mm ballast stand that parks three oscilloscope or multimeter probes tip-down in tapered sockets that grip any 6.4–13 mm probe barrel, so a tugged lead can't drag the holder off the bench. The open rear well takes ~34 cm3 of steel nuts, shot or sand (≈130–250 g), a keyhole comb snaps 4–5.5 mm probe leads for strain relief, a 64 x 7 mm dish holds hook and spring tips, and two 3.4 mm M3 clearance holes let you bolt it to the bench.