Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Stacking Bench Cookie Work Riser
A 60 mm diameter, 30 mm tall puck that lifts a workpiece off the bench, so a router bit, a jigsaw blade or a wet paint edge has room underneath. A 16 mm spigot on top drops into the 16.8 mm socket underneath the next puck, so two of them stack to 60 mm and three to 90 mm without sliding apart. Ridges on the top face help the work stay put, and the inside is hollowed with a 45° cone so it prints without supports and uses about 55 cm³.
Screw-Point Painter's Pyramid Stand
Hollow triangular painter's pyramid, 100 mm corner-to-corner and 48 mm tall. Drive an M3 or #6 screw up through the 2.6 mm pilot bore in the tip so its point holds doors, shelves and boards off the bench while you paint or varnish both sides. Finger notches in each base face make it easy to pick up, and the ~3.4 mm shelled walls keep material use low.