Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Peg-On Drawer Label Holder
A 60 × 20 × 4.5 mm slide-in label frame for the 'Dovetail-Stacking Parts Drawer Cabinet' kit. A 54 × 16 mm paper or card label slides into a 55 × 16.6 × 1.0 mm pocket from the right-hand end and shows through a 50 × 12 mm window. Two split 4.0 mm × 2.3 mm pegs at ±24 mm press into the 4.3 mm holes in the Detent-Stop Parts Drawer front plate, so you don't need glue or tape.
Dovetail Drawer Cell Housing
A 70 × 50 × 130 mm open-front sleeve that holds one drawer in the 'Dovetail-Stacking Parts Drawer Cabinet' kit. Each of its four long faces has an 8/11 mm dovetail groove, so cells can lock to each other in any direction with bowtie keys. Inside are 18 mm ribs, one of which is the drawer rail with a 1.5 mm detent bump. The back plate has two keyholes at ±20 mm (10 mm entry, 5 mm slot) for hanging it on the wall with #8 wood screws. It prints standing on the back plate, so it needs no supports.