Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
19 in Rack Rail Patch Cable Finger
This open-top cable finger bolts into one 1U space on any 19 in EIA-310 rack rail. It gives you a 59 x 22 mm cable bay, about 20 Cat6 patch leads, in place of a $15–30 commercial D-ring. The two mounting slots are 6.6 x 8.6 mm on 31.75 mm centres, so they take M6 cage-nut screws as well as 10-32 or 12-24 screws. A screwdriver port through the front lip reaches the upper screw. The part prints on its side, so the weight of the cables loads the layers along their length, not across them.
Pedalboard Six-Lane Patch Cable Raceway
This low-profile raceway clip screws to a pedalboard slat and holds up to six patch cables. Cables 5–7 mm across press through a 5 mm mouth into 7.5 mm lanes and stay put. The clip is 90 x 20 mm and only 13.5 mm tall, so it fits under most pedal overhangs. Two 4.5 mm holes take #6/#8 wood screws or M4 bolts, and the flat base also takes hook-and-loop tape.