Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Plant Support Ring Clamp For 1/2 in EMT Stake
A pinch-clamp collar for 1/2 in EMT conduit (17.9 mm OD, 18.4 mm bore) that holds an open 70 mm plant ring. You slip the ring around a tomato, pepper or dahlia stem through the 20 mm gate, then lock it at any height with an M5 bolt and a captured nut. The part is 130 mm long and prints flat, so the side load from the plant stays along the layers instead of across them.
3/4 in PVC Poultry Waterer Pipe Hanger
This screw-on hanger clamps a 3/4 in Schedule 40 PVC nipple-waterer pipe (26.7 mm OD) to a coop post or run frame. An M4 pinch bolt with a captive nut stops the pipe from rolling, so the nipples keep pointing straight down and don't drip. Vertical 5.2 mm slots fit #8 or #10 screws (4.2–4.8 mm shank) and give 5 mm of height adjustment for levelling the line. The part measures 62 x 80 x 16 mm and the pipe weight loads it along the layer plane.
Wheelie Bin Pinch-Clamp Axle Bracket
This bolt-on pillow block gives a curbside wheelie bin a new mount for its steel wheel axle after the moulded snap-in mount cracks. Measure your axle first: the split 17 mm bore is meant to pinch about 15.5–17 mm axles, including the common 5/8 in (15.9 mm) size. One M5 pinch bolt with a captured nut tightens the bore. The 96 x 46 x 30 mm block mounts to the bin base with two M5/#10 bolts through 12 mm vertical slots, so you can line it up with the old axle position. Print it on its side so the wheel load runs along the layers, not across them.
Snow Shovel D-Grip Clamp Handle
A replacement D-grip for snow shovels and garden tools with a 1-1/8 in (28.6 mm) wood or fiberglass shaft. It has a 29.1 mm socket, 47 mm deep, with a split top that two M5x20 bolts and captured nuts pinch shut. A #8 wood screw goes up through the bottom into the shaft to stop it from twisting. The grip opening is 86 x 62 mm, big enough for a gloved hand, and it's printed flat so pushing and pulling loads run along the layers, not across them. For 1 in (25.4 mm) shafts, set BORE to 25.9.