Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Window Screen Push-In Pull Tab Set
A set of four replacement window screen pull tabs that push into the spline channel beside the rubber spline, replacing the vinyl tabs that crumble in the sun. Each tab is a 10 mm wide finger loop (15 mm outer diameter, 9.5 mm hole) on a 12 x 2.4 mm base that sits on the frame lips, with a 1.2 mm thick barbed leg in four lengths (5, 7, 9 and 11 mm) to suit shallow and deep channels around a 3.6 mm spline; the whole set prints flat on its side so layer lines run along the loop-to-leg bend and the tabs snap apart on 1 mm thick sprues.
Three-Size Slit-Eye Zipper Pull Set
A sprue of three replacement zipper pulls for jackets, backpacks, tents and gear bags. Each is 44 mm long with a 2 mm-thick head so it passes under the slider bridge, a 3.5 mm eye that is 5, 7 or 9 mm wide, and a 0.8 mm slit you twist open to hook the pull onto the slider without tools. The grip is thickened to 3.2 mm with ribs and has a 3.4 mm lanyard hole, so you can add a cord loop for gloved hands. Snap off the pull that fits and print it in PETG so the slit can flex.