Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Three-Lane Cat6 And Coax Raceway Clip
A low-profile clip that screws to a baseboard or stud and holds three network or camera cables side by side. The 8.4 mm lanes on an 11 mm pitch take cables from 5.5 to 8 mm OD, which covers Cat5e, Cat6 and RG6 coax. Each cable snaps in through a 5.2 mm throat with a V lead-in, so you can run a clean line of drops without a full raceway. The clip is 56 x 11.6 x 16 mm. It prints on its end, so there are no overhangs and the snap lips flex along the layers instead of across them. It mounts with two #6/#8 wood screws or M4 screws through 4.5 mm holes on 45 mm centres.
Strap-On Desk Leg Cable Spine
A 119 x 60 x 21 mm snap-in cable raceway segment that straps to a desk or sit-stand leg and carries the cable bundle vertically: a 26 mm wide x 16 mm deep channel with lips narrowing the mouth to 18 mm so cables push in and stay put. Mounts with velcro or zip ties through two 18 x 4.4 mm wing slots (fits any leg profile) or two 4.5 mm screw holes (M4 / #8 wood screw, 4.2 mm shank), and each segment lap-joints into the next with a 9 mm tongue and 4 mm locating peg so you stack as many as the leg is tall.