Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Hardware Cloth Raised Bed Corner Clamp
This screw-on angle clamp holds hardware cloth or chicken wire around the outside corner of a raised bed, coop or run post, so you don't have to re-staple it every season. It is 90 mm tall with two 34 x 4.5 mm legs. Each leg has gripping ribs that press into the mesh, the inside corner is relieved so the wire bends around the post without kinking, and five staggered 5.5 mm holes take #8/#10 pan-head or washer-head wood screws (4.2/4.8 mm shank) or M5 bolts.
Four-Tine 50 mm Seed Dibber Rake
A hand dibber with a D-grip that punches four planting holes 50 mm apart in one push. The holes are 25 mm deep at full insertion, and notches on each tine mark 10 mm and 20 mm depths for smaller seeds. It is 170 x 89 x 10 mm and prints flat, so pushing it into soil loads it along the layers instead of across them. A 5.5 mm hole lets you hang it on a nail or an M5 hook in the potting shed.
Cattle Panel Screw-On Wire Snap Clip
This screw-on snap clip holds a 4-gauge cattle or hog panel wire (about 5.2 mm, works with 5–6.5 mm wire) to a wooden post or the side board of a raised bed. It fixes arch trellises and garden fences without bulk-only farm-store clips. The clip is 60 x 16 x 24 mm and attaches with two #10 wood screws or M5 bolts through 5.5 mm counterbored holes. The 7.2 mm C-saddle has a 4.4 mm side mouth with a lead-in, so the wire clicks in sideways, and a pull away from the post loads the closed back of the ring rather than the opening.
Garden Bed PVC Hoop Mount Bracket
Screw-on bracket that holds a 1/2 in schedule-40 PVC hoop (21.3 mm OD) vertically against the inside face of a raised-bed board, so row cover, shade cloth or frost plastic can go up and come down without re-drilling the bed. The 22.0 mm cradle snaps the pipe past a 20.5 mm lip, a 23 mm end block stops the pipe sliding down into the soil, and a pair of 5.5 x 3 mm slots through the arms take a 4.8 mm zip tie for wind. 84 x 38 mm footplate with two 5.5 mm holes at 66 mm centres for #8 or #10 wood screws (or M5); print two per hoop.
Raised Garden Bed Corner Post
A corner post for timber raised beds: two perpendicular 39.0 mm channels swallow the ends of any 2x lumber (2x4, 2x6, 2x8 — all 1.5 in / 38.1 mm thick) with 28 mm of engagement, and the open 39 mm centre shaft takes a 2x2 stake driven into the ground to anchor the corner. Five 4.5 mm holes take #8 / M4 screws — one through the outer and one through the inner wall of each channel so the boards are pinned both ways, plus one into the stake. 75 x 75 x 60 mm, constant cross-section so it prints flat with no supports; run it in PETG or ASA for UV life.