Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Shower Wall Twin Razor Drop-In Rack
A 90 x 34 x 60 mm wall rack that holds two cartridge razors. Each one drops into a tapered V-slot, 16 mm wide at the mouth and narrowing to 8 mm, so any handle neck in that range wedges in with the head sitting on top and water drains straight through. Mount it with two #6 pan-head screws (4.0 mm clearance holes) or a strip of outdoor VHB tape on the flat back. It prints ledge-down with three gussets, so there are no supports and no suction cups to let go.
Safety Razor And Shave Brush Stand
A countertop wet-shaving stand that hangs a safety razor and a shave brush bristles-down over a 96 x 56 mm drip tray, so both dry properly and the water lands in the tray instead of on the vanity. The razor fork takes handles from 9–20 mm and catches any head wider than ~30 mm; the brush fork tapers 38 mm down to 24 mm so it wedges on almost any handle, with the razor hook at 128 mm and the brush hook at 112 mm above the tray. Two 4.5 mm holes at 52 mm centres let you screw it to a wall or cabinet side with #8 (4.2 mm) screws instead.