Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
RC Body Clip Graduated Post Keeper
A 120 x 60 mm pit-bench keeper for RC body clips. Six 22 mm dummy body posts in pairs of 6, 8 and 10 mm diameter each have 2.2 mm cross-holes at two heights, so you can snap 1/10, 1/8 and larger-scale R-clips onto them the same way they go on the car. A three-bay 30 mm deep-walled tray holds loose clips and pins. It sits on the bench as-is, or screws down to a pit board through two M4 clearance holes.
1/10 RC Car Pit Stand Parts Tub
A 120 x 80 x 60 mm ribbed stand for working on a 1/10 RC car. The chassis rests on the rib grid, which lifts the wheels off the bench so you can spin them and work on the suspension. Underneath, six 37 mm cells catch the screws, hinge pins and clips as they come out, and thumb notches at each end let you carry it like a tray.
624 Bearing Servo Saver Bellcrank
A compliant steering bellcrank for RC trucks and robot linkages: the hub presses onto a 624 bearing (4 x 13 x 5 mm) and drives two 36 mm output arms through a pair of spiral leaf flexures, so curb strikes deflect the arms ~10° and spring back instead of stripping the servo. 83 x 83 x 7.5 mm, M3 clearance holes at both tie-rod arms and two link positions on the input arm, with the arm sides hitting the ring ends as built-in over-travel stops.